|
Reducer installed correctly |
Proper installation, use and maintenance of gear, machinery and equipment to ensure the normal operation of the important part. So, before you install NEUGART planetary reducer, make sure you installed in strict accordance with the following related issues, assembly and use seriously.
The first step is to install pre-identified motor and reducer are intact, and check the motor and reducer strictly connected to all parts of the size matches, here is the motor of the positioning boss, the input shaft with the gear grooves with dimensions and tolerances .
The second step is under the reducer flange rotating dust holes on the outside screws, adjust the PCS system clamping ring to align the side hole and dust holes, insert the hex tightened. After removal of the motor shaft key.
The third step is the motor and reducer natural connection. Connection must ensure that the output shaft gear reducer input shaft concentric with the motor line, and two parallel lateral flanges. As the heart of a consistent, would lead to the motor shaft gear reducer break or wear.
In addition, installation is prohibited hit with a hammer, etc., to prevent axial or radial force excessive damage to bearings or gears. Be sure to install the bolt tightening force after rotating bolt tightly. Before installation, the motor input shaft, positioning boss and reducer to connect parts of petrol or zinc anti-rust oil wipe net sodium and water. The aim is to ensure a close connection and operation of the flexibility, and prevent unnecessary wear and tear. Connect the motor and gear before you will be the motor shaft keyway and bolt tightening force vertical. To ensure uniform force, first to arbitrary spin angular position of the mounting bolts, but do not tighten, then screw the other two pairs of angular position of the mounting bolts last tightened one by one four mounting bolts. Finally, the rotating force bolts tightly. All bolt tightening force required to indicate the use of fixed torque wrench torque according to data from fixed and inspected. Right angle gearbox with the same type data are not the same straight reducer, also refer the user to pay attention. * Gear and mechanical equipment is properly installed between the reducer and the driving motor similar between the installed correctly. The key is to ensure the speed reducer output shaft must be driven with the same part of the shaft concentricity.
Fourth, the conclusion as the global industry continues to deepen, planetary gear in drive more and more obvious role. Hope in the future use of the process, the planetary gear can bring you more convenience and benefits!
|
|
|
